How to replace a hardwired smoke alarm

- Also, here’s a video they put together showing the steps:. To make proper electrical connections, check out the advice given by The Family Handyman. It’s a matter of simply swapping out the wiring harness. . The most difficult way to replace a hard-wired smoke alarm is to actually re-do the wiring. Even then, however, it’s not difficult ..More

  • Septic Inspectors Amarillo, TX
  • Air Quality Inspectors Columbus, GA
Kura: helping you win at homeownership

- I’m just tickled that there’s a company out there who does all of this home maintenance. . While this is a small list of what they do, these are the items that stick out the most to me. I’ve blogged about most of this stuff because expensive repairs ensue when this stuff is forgotten about ..More

  • Commercial Septic Inspection Oxnard, CA
  • Septic Inspection Fontana, CA
What Can Infrared Technology Do For You? Plenty!

- You can even spot potential problems such as a damp basement or broken section of a radiant in-floor heat system. An uninsulated attic door stands out long before you head upstairs. . The more that you use infrared technology, the more uses you’ll probably find for it. A radiator that doesn’t work properly can’t hide from a heat-sensing camera ..More

  • Sewer Inspection Cost Knoxville, TN
  • Termite Inspector Fort Lauderdale, FL
Inspecting When Louisiana Flooding Happens in Your Neck of the Woods

- . Basements, walls and any area exposed to flood waters are all at risk. Although plumbing doesn’t carry the same life-threatening potential as electrical, the damage can be no less troublesome and costly to repair ..More

  • Roof Inspection Salt Lake City, UT
  • 101 Point Home Inspection Newport News, VA
Subpanels: when the grounds and neutrals should be separated

- The two illustrations below, courtesy of the fine folks at CodeCheck (copyright © 2018), illustrate the difference between a service panel and a subpanel. . Click on either for a larger version. Two hots, one ground, and one neutral wire. Starting with the 2008 National Electric Code, the only acceptable way to wire a subpanel is with a four-wire feed. The grounds and neutrals must be isolated ..More

  • House Inspection Huntsville, AL
  • Discount Infrared Inspection Tempe, AZ

requestaquote Get Free Quotes callnow 888-506-9527